ETERNITY 26 Manuel de l'opérateur télécharger pdf (Page 13)

Only specially trained and authorized technicians

are permitted to service this water heater.

Unpack the unit carefully and make sure that all

accessories are put aside so that they will not

be lost.

Operator's manual

Warranty Card

Additional Parts

Inspect the water heater for possible shipping

damages.

Installation Preparation

PROFESSIONAL INSTALLATION REQUIRED

Unpacking Your Eternal Water Heater

Check the markings of the rating plate on the water

heater to be certain the type of gas being furnished

corresponds to what the water heater is equipped

for.

Do not connect this water heater to a fuel type not

in accordance with the rating plate

WATER HEATER PLACEMENT

Additional Safety Instructions

If vented through an outside wall or through the roof

using 4" vent piping the total vent run cannot exceed

35 feet with one 90 elbow. If more elbows are re-

quired the venting distance must be reduced 5 feet

for every 90 elbow.

Vent piping should slope downward towards the out-

side if condensate collector is not used. Horizontal

runs require adequate support at 3 feet intervals

and vertical runs supported at 5 feet intervals.

Condensation may be created at times as the com-

bustion gases exit the vent cap. Discoloration of sur-

faces in proximity to the vent cap may occur.

Carefully choose the location for the new heater as

placement is a very important consideration for the

safety of the occupants in the building and for the

most economical use of the appliance.

Whether replacing an old water heater or putting

the water heater in a new location, consider the

following critical points:

The location selected should be as close to the

vent termination point as possible, and centered

within the water piping system for best hot wa-

ter delivery. All water heaters can leak. Do not

install without adequate drainage provisions

where water flow can cause property damage.

For other than direct vent appliance, the

appliance must be located as close as possible

to a chimney or gas vent.

The appliance should be located in an area

where leakage of the tank or connections will

not result in damage to the area adjacent to

the appliance or to lower floors of the structure.

When such locations cannot be avoided, it is

recommended that a suitable drain pan be

installed under the appliance. The pan must not

restrict combustion air flow.

The minimum inlet gas pressure must be within

the value specified by the manufacturer and the

minimum value listed is only for the purpose

of input adjustment.

If a water heater is installed in closed water

supply system, such as one having a backflow

preventer in the cold water supply line and a

thermal expansion tank is required, contact the

water supplier or local plumbing inspector on

how to control this situation.

The Temperature and Pressure (T&P) relief valve

must be certified as meeting the requirement of

the Standard for Relief Valves and Automatic Gas

Shut-off Devices for Hot Water Supply Systems

ANSI Z21.22/CAN1-4.4. The valve must be marked

with a maximum set pressure not to exceed the

marked hydrostatic working pressure of the wa-

ter heater (150 psi) and a discharge capacity not

less than the water heater input rate as marked

on the rating plate.

For tank type water heaters, the relief valve

must be installed near the hot water outlet.

WARNING

! !

CAUTION

! !

Before commencing the Installation

Check that it is in accordance with relevant

building and mechanical codes, as well as any

local or state or federal regulations.

Read the Safety guidelines in the beginning of

this manual.

The internal computer controlled regulator is pre-

set by the manufacturer and should not be ad-

justed by user.

Maintain proper space around the unit for servic-

ing. Install the unit so that it can be connected

or removed easily.

The electrical connection requires a means for

switching off the power supply.

Avoid installing the unit in an area with high lev-

els of dust, sand, or debris. These particles may

clog the air vent or impair the function of the fan,

leading to improper combustion. Regular main-

tenance is needed.

Do not install the unit where the exhaust vent is

pointing into any opening in a building or where

the noise may disturb neighbors.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

ETERNITY 26 Manuel de l'opérateur Page 13

Commentaires sur ces manuels