ETERNITY 26 Manuel de l'opérateur télécharger pdf (Page 28)

Electrical Connection

ELECTRICAL CONNECTIONS

Installation Codes:

Follow the requirements of the local authority having ju-

risdiction. In the absence of such requirements, follow

the latest edition of the National Electrical Code ANSI/

NFPA 70.

Label all wires prior to disconnection when

servicing controls. Wiring error can cause im-

proper and dangerous operation. Verify proper

operation after servicing.

CAUTION

The water heater requires a dedicated electrical power

supply of 120 VAC/60Hz, and it must be properly

grounded to function.

Please refer to the Wiring Diagram. Note: There

is a copy located on the inside of the front panel

of the appliance.

A means for switching off the 120 VAC power

supply must be provided.

Wire the heater exactly as shown in the wiring

diagram.

To ensure complete filling of the tank, allow air to

exit by opening the nearest hot water faucet.

Allow water to run until a constant flow is

obtained. This will let air out of the water heater

and piping.

Check all new water piping for leaks. Repair as

needed.

WARNING

! !

The water heater must be electrically grounded.

WARNING

! !

Do not rely on the gas or water piping to ground

the metal parts of the water heater, because

plastic pipe or dielectric unions may isolate the

water heater electrically. Service and mainte-

nance personnel who work on or around the

water heater may be standing on wet floors, and

could be electrocuted by an un-grounded water

heater.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

ETERNITY 26 Manuel de l'opérateur Page 28